[M.Abid]

Hi guys I buy a techno cnc router HD series.
Need to know can I do 3d carving work with this machine and need to process panel doors means work on solid wood also.
How many hours continues run this cnc router? Because 3d jobs take time.
This machine has hsd 4.5 kw spindle.
Yako microstepping drives.


Any suggestions appreciated.

[marcusCA]

Hi Abid, Techno Isel are reliable machines and can cut 3D carving files.
Depending on the jobs, you can leave the machine running overnight and get the result in the morning.
To process panel doors in 3D you can use various strategies with roughing or direct finishing depending on the tooling you have and will need.

Marcus Minor
Application Engineer ArtClip3D
ArtClip3D | 3D CNC Software for Router - Wood Carving Software - V-Carving - Signmaking

[M.Abid]

Thank you Marcus for the information.
Need some more that Techno HD Series has yako microstepping motors Nd drives. How much is the speed or time difference if the same 3d carving job can be done with servo system.

Sent from my GT-N7100 using Tapatalk now Free

[M.Abid]

Hello marcus how are you? Today I power on my techno hd series cnc router every thing is ok but I forget to remove the 2 metal brakets which is bolted on the gantry and the body.
I start the machine and press y+ to move in y direction but the gantry dosent move and vibrate beasuce its fixed.
Now the question is that is their is any damage to the setepper motor or the gear? I press the y+ button for 1 or max 2 seconds then stop when ia saw that its not moving.

Thank you

Sent from my GT-N7100 using Tapatalk now Free

[victorofga]

mabid

its a tricky question..
if you try to mill a 8 feet long boat hull, where you have long slight curves, then servo can yielding..

if you try to machining a relief, likely a 12x18 inches, and it has many small detail, that you have to use 1.5 mm ball endmill or smaller for details, then due to short toolpathsegments, you might cant observe difference..

about how long a router can run ..
the drives for the axises should keep up days long without stop..

spindle with correct cooling also could take several day run without any issue..

for your Y axis..
virtually a motor on the axises has no sufficient power to damage a gear..
but its no good anyway..

try to mill a slight angle.. like 89 deg to the Y axis, across on the table, and repeat it a few couple times from a distance each other.. .. and check surface if it is smooth witout """steps"" then happened nothing to your gears..
however some backlash might developed..

[M.Abid]

Thank you for the reply. Dear in the techno hd series router microstepper motors fixed with shimpo reducer so I hope so reducer is also fine no damge to the reducer.

I just press y exis move button for 1 or max 2 seconds.

Sent from my GT-N7100 using Tapatalk now Free