[nishan]

Hi

I am trying to setup an old Chinese Laser - it has been sitting in a box for 5 years, I got it working. Can anyone advice what type of file does it read ?

I emailed the supplier but no response... It does have a USB reader, so if I can only figure what format to send the file in will help.

Thanks in advance

Nishan

[cautious32]

Hi Nishan

Looking at this website, Boye laser I found the below specs for a V-SPIN-1006. Don't know if this is the same model as yours but it may be similar.

Does the laser machine have any software with it at all?

Have a look at the electronics and tell us what controller it has. This will indicate what software would be needed.

Relevant Parameters
Laser Power： 50W/60
Wlaser Type： CO2 sealed laser tube,water-cooled,10.6 um
Work Size： 850*570
Cutting Speed： 25-40000mm/min
Laser Energy Control： real-timeadjustable
image Recognition Range： 105mm*80mm
Graphics Format Support： DST、PLT、BMP、DXF
Software Support： TAJIMA、CORELDRAW、PHOTOSHOP、AUTOCAD、all type of AUTOCAD software in cloth
Compatible Software： Cut settings organized by color
Dimensions： 1520*1030*1015
Total power： 1000W

[nishan]

I have visited this website and even called them, but language is a barrier. I have sent all those formats to the machine but it does not read any of them. Basically I need a software called laserca.exe .... which reads these formats and then saves it into the format reqd by this machine. ( I think )

Thanks for the help. Will keep u posted.

[grawley]

Provide a photograph of the control card that is located in your laser machine. Often times, there is more than one software that will work on the control card. For example, the Leetro and Googal cards can run the LaserCut software.