Hello
I have following problem with my CNC stepper drivers. I have one 5 axis breakout board USB 5 Axis CNC Breakout Board Interface Adapter for Stepper Motor Driver | eBay and 3 single axis stepper motor drivers like that Single 1 Axis 3 5A TB6560 Stepper Stepping Motor Driver Board Control CNC Router | eBay.
All is powered by the 24V 6,5A power supply, and 5V 1A power supply for tb6560 logic.
I set up the pins as a manual shows. X 2 14
Y 16 3
Z 7 8
Enable: pin 1 for all axis, and output1 pin 9
Result is that all 3 drivers are supplied by the power 24V which power diodes shows, and when I run sample G-code, step diodes are pulsing on the breakout board and on the each of tb6560 driver, but motors do not runing. I can turn shaft easily. When i click on the reset button then all drivers start to "hold" motor shaft and motors and power supply making characteristic noise. When I click on the reset button again everything back to the previous situation.
Sorry for my English because I'm from Poland and still learning english. Please help me to solve this problem.