[RCMARINE]

I RECENTLY REINSTALLED ALL THE PARAMITERS USEING THE 0501. ALL WENT WELL. THE ONLY PROBLEM I HAVE IS THE X AXIS ONLY MOVES IN THE MINUS DIRECTION REGUARDLESS WEATHER I PRESS X+ OR X-, IT ONLY MOVES IN THE MINUS. IS THERE A PARAM THAT I SHOULD CHANGE , ANYONE KNOW?

[EXLASer]

Hi ,
This might be caused by the poor connection of the motor wires of X axis . You can check if X axis motor wires are open or not by a amperemeter .

Best regards,
Mary

[RCMARINE]

THANK YOU MARY

YOU SEEM TO KNOW ABOUT THE DSP CONTROLLER, IF YOU DON'T MIND CAN YOU EMAIL ME AT [email protected]

I HAVE SOME NOTES THAT I'M NOT SURE ABOUT. I ALLWAYS HAD A TECHNO CONTROLLER, THIS DSP IS ALL NEW TO ME.

BY THE WAY A WIRE WAS LOOSE ON THE X AXIS BOARD, THE X WORKS FINE NOW, THANKS. BOB C

[EXLASer]

Hi Bob ,
It is good news that you fixed it . I had sent email to you this morning and you are welcome to ask me any unsure notes in future !

Have a nice day !

Best regards,
Mary