Can anyone help me with my problem on our "DMC 64V Deckel Maho Machine" with "Fanuc" controlls?
I need now, how activating the touch probe, before I call the measure cycle.
I need a list of M-functions to see what of M-function can be activated the sensor.
Measuring cycles are called as G-functions (G2020, etc ...), but when I call one of thes cycles, the sensor is not activated.
Results 1 to 3 of 3
-
11-17-2013, 08:15 PM #1
Registered
- Join Date
- Jun 2009
- Posts
- 146
M-code for deckel maho 64V linear with Fanuc 16iMB controller
-
11-22-2013, 12:02 PM #2
Registered
- Join Date
- Jun 2011
- Posts
- 0
Is this a fault, that were from begin. In my machine, I bought the IR-eye for the touch-probe, because a later integration were much more expensive. When I want to first use the probe, the IR-Eye wasn't correct connected.
-
11-22-2013, 10:35 PM #3
Registered
- Join Date
- Jun 2009
- Posts
- 146
But if he was not properly connected, then it has not worked in the "JOG" mode, or is it?
I can measuring in the "JOG" mode, but when I put the cycle in the program, then don`t work in "automatik" mode...
Reply With QuoteSimilar Threads
-
Deckel Maho FP3- new project
By keven88 in forum Deckel, Maho, Aciera, Abene MillsReplies: 1Last Post: 12-05-2023, 09:50 AM -
deckel maho dmu 50 t
By gunz in forum Deckel, Maho, Aciera, Abene MillsReplies: 11Last Post: 12-24-2021, 01:54 PM -
Deckel Maho DMU 50 VL
By waltteris in forum Deckel, Maho, Aciera, Abene MillsReplies: 3Last Post: 11-13-2016, 09:32 PM -
DMG Deckel Maho Post
By aldepoalo in forum BobCad-CamReplies: 1Last Post: 03-24-2014, 03:05 PM
Posting Permissions
