hi everybody,
i have purchased a chinese spindle rated 3 phase 220v 400hz 1.5kw, and an LG SV-IC5 frequency inverter (manual: http://www.rototech.com.au/pdf/SV-iC5.pdf) .
Please may you advice me with the least I should do to run the spindle.
I mean do I have to connect reactor or brake resistor or it is not necessary in my case?
another question is how to control the inverter via mach?will i need an intermediary circuit or interface between the hobbycnc board and the vfd?
thx in advance
Results 1 to 2 of 2
-
11-25-2013, 09:31 PM #1
Registered
- Join Date
- Mar 2006
- Posts
- 58
vfd and spindle installation and settings
-
11-25-2013, 09:40 PM #2
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24220
Via Modbus A new Huanyang VFD plugin
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
Reply With Quote
Similar Threads
-
Installation and evaluation of the NM-200 Series 2 AC spindle motor replacement kit
By iGAK in forum NovakonReplies: 13Last Post: 04-03-2014, 03:31 AM -
frequency inverter installation and settings
By shreifali in forum Phase ConvertersReplies: 0Last Post: 11-22-2013, 07:38 PM -
X1 Spindle control relay installation (belt drive)
By fragger6662000 in forum Benchtop MachinesReplies: 2Last Post: 04-19-2010, 11:55 AM -
Bridgeport spindle bearing installation
By L98FIERO in forum Bridgeport / Hardinge MillsReplies: 22Last Post: 01-24-2009, 06:39 PM -
Installation of spindle speed sensor
By Bloy2004 in forum CNC Machine Related ElectronicsReplies: 7Last Post: 01-28-2004, 04:50 AM
Posting Permissions
