Colleagues, I have a very difficult question. Currently working on Moriseiki NMV8000 DCG During automatic calibration of the probe (I have attached the ring on one of the pallets) I would like to parameters are automatically saved to work settrer. I use inspection plus the automatic measurement but also sometimes need to measure something by hand and in this case I have to enter manually in the length and radius of the probe caps to use the work setter.
Results 1 to 2 of 2
-
12-01-2013, 05:49 PM #1
Registered
- Join Date
- Dec 2013
- Posts
- 3
Automatic recording of probe calibration to work setter
-
12-02-2013, 12:11 PM #2
Registered
- Join Date
- Dec 2013
- Posts
- 3
I think that you do not understand my question if it's true. There is someone who works on machines NMV5000 OR NMV8000 and perhaps even on other machines with the system Mapps IV ?
The photo showed where it wants to automatically save data after the end of the calibration probe using renishow to work setter
Attachment 211346
Reply With QuoteSimilar Threads
-
1/8" (0.125) Automatic Edge Finder/Setter
By xcayba in forum Calibration / MeasurementReplies: 0Last Post: 02-12-2012, 07:14 PM -
Hyundai tool setter calibration
By Dr Evil in forum Hyundai KiaReplies: 2Last Post: 04-25-2011, 10:46 PM -
automatic tool length setter
By Scottyb in forum Mori Seiki MillsReplies: 1Last Post: 01-25-2011, 05:15 PM -
Probe calibration
By kprice1658 in forum Tormach Personal CNC MillReplies: 3Last Post: 10-25-2009, 09:56 PM -
Work Probe Calibration
By JWB_Machining in forum Haas MillsReplies: 12Last Post: 10-27-2008, 03:42 PM
Posting Permissions
