[mattlynx]

New m/c arrived today and was installed only when we turned it on the turret wouldn't index throwing up alarm no. 2047 turret clamp switch or turret control unit alarm. What does this mean ? Could it be during transit as it worked four weeks ago


Sent from my iPhone using Tapatalk

[ifixcnc]

There is a white servo drive box in the electrical box, check to see if there is an error core displayed. If so check the book for the alarm meaning. The battery may have failed.

[mattlynx]

Thanks will look tomorrow


Sent from my iPhone using Tapatalk

[The Blight]

I think this was the alarm I got 4 days ago when I pressed cycle start before the turret had locked in place. I could not find it in any of the manuals, so I can't say for sure what it means. It just said to check the servo controller board. -> Good tip from ifixcnc. Tell me if you find the code in any of the manuals.

[mattlynx]

Think it might be the battery guys sounds like a simple remedy locating the battery is not though


Sent from my iPhone using Tapatalk

[ifixcnc]

You can buy an single A holder, and just splice the wire. Radio shack has everything you need. 3.6 lithium cell and the holder. I have done this many times, and next time you just pop in the replacement cell. You will have to put the parameters back in the drive. They are in the blue parameter book.

[mattlynx]

Sounds easy I'll have a crack tommorow it showing an alp alarm on the turret drive


Sent from my iPhone using Tapatalk

[dhardt]

mattlynx,
If you run into problems, give us a call.
Doosan Infracore
973-618-2500

I will be out of the office for most of December(vacation and factory training in Korea), but someone in service can assist you...

[dhardt]

mattlynx,

We sell the batteries for those drives.

Contact Lubos Mlynar, Doosan Parts Manager, for assistance in getting the right one for your machine, of the available types.
He can be reached at [email protected]
send him the numbers that are on the battery and he can help you get the correct replacement.

[mattlynx]

Thanks guys we located battery and should have it tomorrow hopefully then it should just be a case of restoring parameters. I think it's because m/c has been standing for so long


Sent from my iPhone using Tapatalk

[mattlynx]

Thanks dhardt


Sent from my iPhone using Tapatalk

[mattlynx]

Ifixcnc thanks


Sent from my iPhone using Tapatalk