584,850 active members*
4,393 visitors online*
Register for free
Login
IndustryArena Forum > CNC Electronics > Gecko Drives > G320 motor tuning issue with Fluke 124 scope
Results 1 to 2 of 2
  1. #1
    Join Date
    Jul 2007
    Posts
    70

    G320 motor tuning issue with Fluke 124 scope

    I have a fluke 124 oscilloscope and am trying to tune my motors but can not get anything that closely resembles the wave form in the manual.

    I have channel A on the test point & the ground lead on the test gnd. I have channel b on the Dir terminal. trigger set to normal & trigger set to channel b.

    Can someone give me some pointers on how to setup this particular oscilloscope??

  2. #2
    Join Date
    Jul 2007
    Posts
    70
    No One??????

Similar Threads

  1. Servo tuning without an O-scope
    By southernexplore in forum Gecko Drives
    Replies: 4
    Last Post: 02-01-2017, 01:15 PM
  2. Tuning with and old-school O-Scope
    By MattTheNoob in forum Gecko Drives
    Replies: 1
    Last Post: 04-19-2014, 07:48 AM
  3. G320 servo motor tuning
    By robhrzic in forum Gecko Drives
    Replies: 12
    Last Post: 11-01-2007, 07:35 AM
  4. G 320 tuning w/scope
    By Cruiser in forum Gecko Drives
    Replies: 12
    Last Post: 09-08-2006, 04:18 AM
  5. Tuning Servos with out an O-scope?
    By Bird_E in forum Gecko Drives
    Replies: 2
    Last Post: 02-23-2005, 07:16 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •