Hi Guys
Wich program I can connect to an okuma osp5000L for DNC this machine?
Hi Guys
Wich program I can connect to an okuma osp5000L for DNC this machine?
No DNC available for a 5000L, was a VERY special option on the 5020L. If your only wanting RS232 communications, anything will work. Lots of free ones available, even hyperterminal would work.
I think Underthetire is right, full DNC ie; drip feed isn't available for that one...however if you just want to upload and download files, there are several easy and free methods as well as the more advanced (read $) methods. That machine control can communicate through it's RS-232 port.
For example: eNETDNC Lt - eNETDNC
Best regards,
Thanks Dear Okumawiz
can i do with Cimco?
if yes,with how much baud rate or .... ????
Should be able to do it with most communication software. Typically run 9600,7,E,2. Not had much luck at higher speeds with any distance.
Best regards,
an early 5000l might not communicate above 1200 baud, and requires hardwire handshake. a 5000lg would do 9600.
Sent from my Quantum using Tapatalk
Thanks all