Running a machines shop leaves little time for software development. Recently I needed to write programs for our Jig Center 7 so I dusted off tahlcam because I never really learned much about our two seats of mastercam. I was impressed at how good it still works. It is actually easier to use than mastercam. I kept asking my self why I did put more effort into exposing my people to it. Tahlcam currently will run in any autocad version through 2014. If someone wants to set it up at their place I would be willing till help them do it on an individual basis now that the GUI can can run on atutocad versions later than 2004. If you know something about autocad you can learn tahlcam in a couple weeks.

Call me at 520-403-9002
Jim