Hey guys,

I'm building a new vacuum table for my CNC at the moment and was running a fairly straightforward program... basically just some pocketing op.

I use WinDNC to drip feed the programs to my Fagor 8025m (I know it's old).
... When dry running - all goes fine, no errors, nothing.

however when I run the program for real, well at some point it stops dead still (still rotating though) and displays an ERROR 000
The manual however does not even have an entry for ERROR 000 - the error code listing starts at 001 ?!?
Also it gets even weirder: If I re-run the same program from start - the error still happens -but at a different point in the program.

Either I'm doing something really stupid, or there must be trolls or gremlins in my controller ... (I know there's a ****ty troll somewhere hiding in my shop... he breaks tools and hides important stuff... but does he really need to mess with the fagor?)


Well if anyone has an idea, I'm really open to suggestions.
If not I'm calling in a priest for some machine exorcism.


thanks

Daniel