I do not know where to start. I am building a movie camera crane that I want to program its moves. That is I want to hand move the camera on the end of the crane and record the movement. Then push play. The camera will then follow it's hand made path.
the crane and record the movement. Then push play. The camera will then follow it's hand made path.
It seem as if that is not to far off a table CNC router.
I don 't mind doing the research, but I need a word of direction to look for the information.
I found a Model radio control "servo" programmer that will allow what I want to do. it is too light weight. my machine will weigh 350+ pounds.
I have a slight understanding of Home made CNC. I have a machine shop at home.
So, is there a recorder for heavier servo??
Please if you can, point me in the right direction.
I am aware that I should check this forum...I just don't know where to look.
I have googled "record cmc movement" with little results.
Thank you in advance.
Tom Knox
[email protected]
[email protected]
252-813-7883