I'm close to pulling the trigger on Mil Standard, but I'm concerned that it is 2D only. Would that mean X and Y only and no Z? Should I wait until I can afford Mill Pro? The lack of 3D seems like a serious limitation. I have just a Tormach PCNC1100 and I have always manually coded. I don't even use their"Wizzards". I don't know CAD and even less about CAM. I've watched a few of the Dolphin videos but will need an instruction manual. In the videos the guy does a fine job but he already knows which "tool" to select and where to find it. Nice instruction for a person who already knows the system, but then such a person wouldn't need the videos. I have Ver. 11 of TurboCad, but it seems to be more oriented to architecture rather than machining.