I have a OKK hm40 that would not execute any drill cycle.
If program line show G98 G81 Z R F it would not execute, I doesn't alarm or have any message, spindle would spin and coolant but will not execute or move to next line. If I do G98 G81 X Y Z R F, then it would execute but would not move to next hole. It would not move to new line but stay at the same line, just stuck or froze basically. The machine seem to recognized the G code. It weird, I have never had this problem before. I have another Okk with meldas 300 and it never have this problem. Same code same program peck and drill just fine. Am I missing something in the control or parameter?
Results 1 to 2 of 2
-
12-03-2022, 08:02 AM #1
- Join Date
- Sep 2022
- Posts
- 3
Meldas 500 won't execute G81,G83, canned drill cycle etc.
-
12-04-2022, 01:33 AM #2
- Join Date
- Sep 2022
- Posts
- 3
Re: Meldas 500 won't execute G81,G83, canned drill cycle etc.
Figured it out. Go your parameter and find m2foml and change it to 0
Reply With QuoteSimilar Threads
-
Mitsubishi Meldas 600M control won't run G83 peck drill cycle
By mscav219 in forum Mazak, Mitsubishi, MazatrolReplies: 0Last Post: 11-08-2018, 04:30 PM -
spindle rotate during G83 canned cycle
By Andriy77 in forum Haas LathesReplies: 3Last Post: 11-02-2016, 01:47 PM -
Mazatrol T-plus G83 Drill Cycle won't behave!
By ncimike3 in forum Mazak, Mitsubishi, MazatrolReplies: 0Last Post: 10-07-2014, 04:54 PM -
G83 Canned Cycle
By jammer66 in forum FanucReplies: 3Last Post: 02-01-2011, 12:15 PM -
fanuc 15i problems with g81 canned drill cycle
By KyDeano in forum FanucReplies: 2Last Post: 01-20-2006, 08:39 PM
Tags for this Thread
Posting Permissions
