[Petermck]

I installed the Fanuc Post Processor form PowerMill. It seems to generate codes OK., but i get a funny move upon startup after a G43 Code and the spindle gets lost on the X and Y axes on a tool change. Am I using the wrong post? Here are the relevant Sections from the code. Look at N 320 and N37340:

FIRST PROBLEM (at program start)
N210 ( STRATEGY USED : Offset_area_clear )
N220 ( TOOLPATH WP : Top )
N230 ( ================= )
N240 ( TOOL TYPE : ENDMILL )
N250 ( TOOL NAME : 1 )
N260 ( TOOL DIA.: 0.1875 & TIP RAD.: 0 & LENGTH : 0.9375 )
N270 T1 M6
N280 G54 G90
N290 S4000 M3
N300 M8
N310 G0 X-.0009 Y-.2066
N320 G43 Z.4375 H1
N330 X-.0484 Y-.2132
N340 Z-.1825
N350 G1 Z-.405F2
N360 X-.0465 Y-.2257F4
 
SECOND PROBLEM (at tool Change)
N137230 G0Z.6
N137240 M9
N137250 Z.8925
N137260 X-.6571 Y.4806
N137270 ( ================= )
N137280 ( TOOLPATH : 2 )
N137290 ( STRATEGY USED : Surface_machine )
N137300 ( TOOLPATH WP : 1 )
N137310 ( ================= )
N137320 G91 G28 Z0
N137330 G49 H0
N137340 G28 X-.6571 Y.4806
N137350 ( TOOL TYPE : BALLNOSED )
N137360 ( TOOL NAME : 2 )
N137370 ( TOOL DIA.: 0.5 & TIP RAD.: 0.25 )
N137380 T2 M6
N137390 G54 G90
N137400 S2700 M3
N137410 M8
N137420 G0 X-.6571 Y.4806

[Bikov]

You can try this opt file