Dear All,
we recently had to replace our spindle optical cable due to the old one being chewed up by a rogue rat. After replacing the cable we lost all the parameters on the machine. we had a backup so we restored the system.
Now all the axis are running fine(homing etc), spindle run fine (chuck clamp de-clamp ok).
the turret clamp light keeps blinking and an error EX 344 Turret param. must be 8.10.12 appears on screen.
we manually moved the turret back to tool no 1 position . It clamps de-clamps fine . we also check the ladder it shows up high low there two.
Does any body know which are the d parameters I should be playing with to get this machining running.
also if there is any turret homing procedure.
Please note we do not have any machine builder manuals or electric diagrams for the machine.
thanks in advance.
Rohan