Hi all, Thanks for the massive knowledge base here. I'll be sure to help when I can but I need some help myself.

I have an Enco lathe Model:110-2032, MFG Date: 1992-1

I had to replace the belts and the motor starting capacitor. Once it was all back together I found issues.
Seem to be in the control circuit.

The drum switch does not turn motor on in either direction.
The emergency switch works properly.
When i press and hold either of the motor relay buttons it operates flawless.

Upon further investigation I found the relay does not click open and closed.
I checked DCV coming out of the bridge rectifier and it only gives 6.54.
The relay is an OMRON type F MY2...listed as 12v but says 24v on the coil inside...
I replaced the bridge rectifier with the exact same replacement part and I still only get 6.54 DCV.
If I jump the relay connectors the drum switch it still does not operate correctly.

I searched all over the web and can not find schematics, at least not for this specific model.

Any assistance would be greatly appreciated.
I have pictures and can post all details asked of.
Thanks again...