[Clonekid54]

We have an LU15-w with OSP E100L controls. The parameters got wiped and no backup disk. Trying to get everything back to normal. I got it running again, but now when using G141 to select the sub spindle, the Z axis is the same as from the main spindle. (Positive Z movement is towards the Sub, not away from it.) I was wondering if there was a parameter for this or is it something to do with setting zeros? Thanks.

[Riddersholm]

The back up disk should be in the electric cabinet on the back of the machine

[Clonekid54]

The parameters got wiped and no backup disk.

Its not in the electrical cabinet.

[tea hole]

Were you able to solve the issue?

[Clonekid54]

Yes, I got it solved. On my machine it was optional parameter 35 bit 6. Something about mirroring Z axis for subspindle... I forget actual wording. Funny thing is I found this a few days ago and tried to change it but it requires a power off restart to change. The part I missed a few days ago is you have to hit "back up" on the menu BEFORE powering down.. I finally read the actual alarm message for "Power on parameter change".. go figure... Live and learn..