Hi,
I just purchased kflop and konnect, and study them using wires and multimeter. Konnect connected to JP6, LED lights on it. I can`t read any input and can`t write any output. LED lights at the input 0 but command Readbit1024 from console always returns 0. I try to open the output 15 through window DigitalIO-Virtual/Kstep and using SetBit63 command in console, the LED does not light up at the output is not open. I have not found whether it is necessary to specify somewhere that konekt connected to the board, perhaps this is determined by the reset pin. What am I doing wrong?