[Kholm3]

Hello dos somone now if its posible to out put x and y coordinate from IGF.

[underthetire]

If the machine has a Y axis...
Not sure of your question. IGF posts to G-code, doesn't run programs in IGF graphic mode.

[OkumaWiz]

If you are milling and working on the face of a part it is possible with G137 mode to get X-Y coordinates output to your G-code. Otherwise Y-axis machine is needed to get Y-coordinates.

Best regards,

[Kholm3]

When i draw programs in igf I use x any y
but when u out put program its in x and c
x and c are more difficult to change.

[OkumaWiz]

If I remember right, there is an IGF parameter that lets you select X-C OR X-Y output. Dig through those on your machine to see if it's in there.