[777funk]

Is there a work around for this?

I'm trying to select a series of points to center drill (also tried engrave). At first it was crashing, now it's at least continuing to run, but geometry isn't selecting.

It will however let me select lines (just not these points).

[jrmach]

Is there a work around for this?

I'm trying to select a series of points to center drill (also tried engrave). At first it was crashing, now it's at least continuing to run, but geometry isn't selecting.

It will however let me select lines (just not these points).

Can we look at file ?

[RAF.]

Is there a work around for this?

I'm trying to select a series of points to center drill (also tried engrave). At first it was crashing, now it's at least continuing to run, but geometry isn't selecting.

It will however let me select lines (just not these points).

Maybe check to make sure mask is checked All Mask

The Green check mark is turned on.

[jrmach]

Also you don't engrave points.