Hello Everyone!

Been away for a while just getting used to working with this new machine (CRP PRO 4x4). In general, it's running GREAT!

Did some test cuts, cut a few things for friends, experimented with different settings and materials, etc.

It has been very helpful reading the various posts. I've had a lot of my questions answered just by following others' footsteps.

I've been experimenting with the acceleration settings of my X & Y. Seems that somewhere between 20 and 30 Inch/Min/Min gets the best results while cutting wood at 100-160 Inch/Min. Went down as low as 10, but found that I was getting corners rounded off that should have been square.

Can I get a few opinions from you folks on your acceleration settings AND why/how you came to those conclusions? Do you guys have a tuning method to find a sweet spot?

Thanks, Bernie