[imjustakid]

I am currently trying to use an in program pallet change to install bushings after boring an i.d. We have a mori nh4000dcg. program after machining prior to pallet change is as follows: "G91 G0 G49G30Z0M19;G30X0Y0M11;G28B0;M60;M0;M60;.......... .."

I am getting nc alarm 5010 End of record after it reads the M60 line(both ways)..... Any ideas???

[underthetire]

Is this in MDI or auto?
If in auto, where is your m30?

[imjustakid]

I am currently trying to use an in program pallet change to install bushings after boring an i.d.

So yes it is auto. MDI is a simple M60 for pallet change, but I can't integrate it into a running program.

No need for M30 being as I am picking up the program after the M0 stop prior to the M60 to bring it back into the machining area.

Essentially, I just want to switch my pallet out to install bushings. After installing the bushings, I want to continue with the program I was currently running by switching the pallet back in to be finish machined.

[Tafc7306]

Does M60 work in MDI mode? If it does, what I found is using M60 in a program, the button on the outside of the machine needs to be in the locked position (light on) In MDI mode the switch does not need on, just to have the doors closed.
Hope that makes sense.

Jeff