I hanve a hitachi-seiki lathe with fanuc 6t controls on it. I change the parameter for the rs232 baud rate and now my spindle want stop turning in the m03 direction. I think i might have change a wrong number some where.The m05,m02,m30 commands want stop it but the controls see it.When i power up the machine the spindle starts turning slowly in the m03 direction.Can anybody help me on this?
Thanks Doug
Thread: parameter list
Results 1 to 5 of 5
-
07-05-2006, 01:41 PM #1
Registered
- Join Date
- Jul 2006
- Posts
- 5
parameter list
-
07-05-2006, 03:38 PM #2
Member
- Join Date
- Mar 2006
- Posts
- 1625
did you program a speed (S2000)
-
07-05-2006, 08:24 PM #3
Registered
- Join Date
- Jul 2006
- Posts
- 5
mike
I can change the speed up and down. if i change it up then down to s1 rpm the spindle will stop for a few seconds, then i can m04 the spind and run the speeds up and down. When i do that and m05 the spindle stops and reverse direction.Then manual spindle stop button don't work either. the only way right now to stop it is to power down. I have down loaded a cycle program but it all want fit and i was also thinking about deleteing it out just becaus it don't have a m30 command in it.What do you think?
Thanks Doug
-
07-05-2006, 09:18 PM #4
Community Moderator
- Join Date
- Dec 2003
- Posts
- 24221
Do you not have the original parameters to load back in?
Al.CNC, Mechatronics Integration and Custom Machine Design
“Logic will get you from A to B. Imagination will take you everywhere.”
Albert E.
-
06-17-2008, 05:56 AM #5
Registered
- Join Date
- Feb 2008
- Posts
- 5
i think the problem not come from parameter, have you ready check i/o signal from diagnostic page and check all signal has completed.:wee:
Reply With Quote
Posting Permissions
