I'm sure everyone else has had trouble with finding a good post processor for the tree J325 using bobcad cam V24 like I have as far as just downloading it and it working flawlessly programming through the EIA, and being stuck with one that will work on your mill but won't let you use your BBC software to its full potential like I was, so yesterday I was bound and determined to modify one to get the full potential of my software and the mill, after countless hours of trial and error I finally did it I have a postprocessor that runs my BBC and mill at its full potential!! Needless to say im stoked! And truly was missing out on what my mill was capable of, believe it or not I started out with the PP for the delta 40-60 with EIA no ATC and heavily modified it to work on the delta 20. Has anyone else done this?