Hi to everybody,I'm asking for help.
I just bought a 1997 kitamura my center1 with Yasnac i80 control.
the problem is that i was doing zero-return and I went too far (over the soft switch) so I reset the machine and tried to move away, accidentally, I went to opposite direction, meaning farther away over the second switch. Now I have alarm 11 and I can't reset the machine.
please help me to get out from over travel on x axis.
note... I already have try 2nd LS sw + reset softkey
Results 1 to 3 of 3
-
05-21-2014, 04:36 PM #1
Registered
- Join Date
- May 2014
- Posts
- 2
kitamura mycenter1, axis over-travel
-
05-21-2014, 05:12 PM #2
Gold Member
- Join Date
- Feb 2009
- Posts
- 6028
Re: kitamura mycenter1, axis over-travel
2nd LS sw +POWER ON+ reset softkey
some must be in pulse handle mode to move off.
-
05-21-2014, 05:49 PM #3
Registered
- Join Date
- May 2014
- Posts
- 2
Re: kitamura mycenter1, axis over-travel
Thank you for the reply but I tried that and it doesn't work.
The hydraulic are down and I also have these alarms:
Emergency = move,
2nd limit =move,
NC Unit = NG
Similar Threads
-
Increasing the axis travel on Kitamura Mycenter 1
By mclausen in forum KitamuraReplies: 0Last Post: 03-14-2014, 03:15 PM -
Kitamura Mycenter1/485 Parameters lost
By huub in forum KitamuraReplies: 0Last Post: 12-24-2010, 10:18 AM -
Kitamura Mycenter1
By rai in forum FanucReplies: 2Last Post: 12-18-2010, 11:53 PM -
kitamura mycenter1 backlash
By jfrv86 in forum KitamuraReplies: 0Last Post: 06-15-2010, 08:57 PM -
KITAMURA MYCENTER1
By Eric MFG in forum Uncategorised MetalWorking MachinesReplies: 4Last Post: 11-03-2009, 01:27 PM
Tags for this Thread
Posting Permissions
