Hello.
I just buy a MORBIDELLI author 600kxl that goes with the XiLog plus.
however'm also trying to work with alphacam 2013 r1 as I have to record some logos that I have in dxf.
however, once I get to do the machining (more or less) to open it in the XiLog me appear as if I was watching the board from below, ie, all letters as if in a mirror.
not know if I've explained well ... Maybe it's an issue of the origin coordinate, since I "zipcode cn for each panel uses bottom left point x0 y0" appears Although then I've been moving the origin of the work table for all the sites out well. any ideas?
I put a couple of photos for you to see my problem.
Thank you in advance.
Attachment 237644Attachment 237646