I have a 1993 Fanuc Robodrill T10a. I had a part come out of the vise and it actually snapped the tool holder at the pull stud. Now the top part of the stud is in the spindle and I get an "EMG" flashing as well as a 1006 error code. The 1006 basically says there is no tool in the spindle. I cannot move the X, Y or Z axis and can't figure out how the heck I am going to get that piece of the stud out. Any suggestions or advise would be GREATLY appreciated. We are down and this is our only 3 axis CNC! HELLLLLP!!!!