[kathy2707]

Hello, I just got a new cnc machine and I need some help and training, I am located in the fort Lauderdale area, if someone can help me please email me at [email protected] I will pay compensation for all your time

Thank you
Kathy

[oneshao]

Hey Kathy2707,

I am in Boynton Beach I realize this post is quite old, but was wondering if you found someone to assist. I am looking for some help as well. Perhaps you know a referral?

[R1_pilot]

Oneshao,

What exactly are you looking for help with?
What kind if machine do you have?


Sent from my iPhone using Tapatalk

[oneshao]

R1_pilot
I've got a k2 wood router. Small hobby type machine I acquired from a former employer (RAASCO GRIPS) the problem I'm having is "emergency estop requested" cannot seem to figure out why. The machine was operating perfectly for the last 6 months. Searched forums and interwebs for solutions, tried a few from peeps with similar issues to no avail. I'm at a loss, not to mention I'm somewhat of a novice when it comes to mach3 and electronics. Thanks for your time