hi all
I need some help with my Twinhorn mill with fanuc 0i-mc control, 2007 year
the PWE 8900 parameter wont change, I am in emergency stop and in MDI mode it keep blinking ''WRITE PROTECT''
I dont have the fanuc books so any help would be grateful
the machine is working fine I just bought it but it is set to work on the memory card parameter #20 is 4, what is the parameter
that should stand there in order to use the RS232 comunication?
I dont have the memory card and this control does not have Ethernet
this are start up details about the software:
OMM : DX37 -05
PMC : V1 - 30
please help