[KHOATRANNGOC]

Hello,
I have the CNC machine OKUMA OSP5000 MC-4VB.
Now I want to change type 8 inch floppy to 3-1/2 inch floppy.
Now type 8 inch floppy the bab. It can not run.
Do you have the drawing pinout " 50pin " of type 8 inch " DDF8-3D-41A " floppy osp5000?
Please you see the picture of type 8inch floppy.
Please help me. I will send the gift to you.
My email : [email protected]
Thank you.Attachment 241450

[MMA]

Hi.
I'm wondering if you could did this, because i'm trting to do the same operation to a Okuma LC40

[KHOATRANNGOC]

Hello,
Have you the manual and floppy disk of the Okuma ?
Please support for me.
Thank you,

[fordav11]

the drive was probably built more than 35 years ago. you will be lucky to find anything about it now.
pull the drive out of the frame and look for the REAL manufacturer (not Okuma)
and the model number. then report back here with that info.

[KHOATRANNGOC]

Hello,
Have you the disk software of the Okuma Osp5000M-G MC-4VB ?
Thank you,

[Superman]

Hello,
I have the CNC machine OKUMA OSP5000 MC-4VB.
Now I want to change type 8 inch floppy to 3-1/2 inch floppy.
Now type 8 inch floppy the bab. It can not run.
Do you have the drawing pinout " 50pin " of type 8 inch " DDF8-3D-41A " floppy osp5000?
Please you see the picture of type 8inch floppy.
Please help me. I will send the gift to you.
My email : [email protected]
Thank you.

That machine only came with 8" system disks & drive.....also had a reel-to-reel tape reader

Trying to change to a 3-1/2" drive and all your machine disks are then useless, & you will never be able to resurrect your machine to working condition if a problem occurs....... on a machine of that vintage, it could be tomorrow

Get the RS-232 working, as PIP is standard ( better if you had the DNC option ) for the loading of programs
-
and ..... say goodbye to using floppies ( floppies in the workshop don't last very long, & they also are becoming rarer )

[MMA]

Hi KHOATRANNGOC

I have the manual and the disk software but the disk drive isn't works, so i want to change the type of floppy because i have the software in 3 1/4 disk too.

tell me if you need any information of the manual.

[KHOATRANNGOC]

Hi KHOATRANNGOC

I have the manual and the disk software but the disk drive isn't works, so i want to change the type of floppy because i have the software in 3 1/4 disk too.

tell me if you need any information of the manual.

Hello,
Please send to me of the picture disk software.

Thank you,

[HUICHO]

hola buen día Tengo un problema con la unidad en mi okuma control osp5000 Espero que aún tenga el manual y que pueda compartirlo:
[email protected]
saludos