Hi,
When I execute the program to run the machine, when G01 activated, no movement was make during spindle rotates. But when when I stop the spindle, the table move in G01 mode.
That anybody facing the same problem?
Results 1 to 10 of 10
Threaded View
-
07-03-2014, 08:17 AM #1
Registered
- Join Date
- May 2008
- Posts
- 11
G01 no movement during execute the program
Reply With QuoteSimilar Threads
-
How do I load and execute a program off of floppy
By bill guinn in forum MilltronicsReplies: 2Last Post: 11-18-2020, 05:35 AM -
need some tip/trick to execute a design
By ric_on_action in forum PhotoVCarve and VCarve ProReplies: 2Last Post: 03-31-2014, 01:52 AM -
How to execute a cnc program without logging to the execute mode of the graphical use
By sabreen in forum CNC (Mill / Lathe) Control Software (NC)Replies: 0Last Post: 02-04-2008, 12:29 PM -
How can I execute an m-code in the middle of a toolpath?
By GeorgeRudd in forum Uncategorised CAM DiscussionReplies: 7Last Post: 12-29-2005, 09:29 PM -
How do you make Bridgeport execute program?
By Bill Gillen in forum Bridgeport / Hardinge MillsReplies: 10Last Post: 06-14-2005, 02:26 PM
Posting Permissions
