584,850 active members*
4,305 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Join Date
    Jun 2006
    Posts
    22

    Need Custom macros for Fanuc 3M

    Well, I am a month or two into figuring out my mill, and I see in the Fanuc manual that it came with some nice canned programs (macros for Bolt Hole patterns, pockets, etc - 8 in all I think) that are no longer resident in the control memory (it was in storage for 6 years). Can anyone tell me where to re-aquire the code I can input to re-enable my machine to run these macros? I suppose I could spend a few weeks re-inventing the wheel here, but I have to believe this code is availble out there somewhere.

    Thanks for any help.

  2. #2
    Join Date
    Feb 2006
    Posts
    992
    I is an option you have to buy. If you didn't buy this option I don't think you can use these feature. One way to test if these option is go to MDI and type in G-code you intend to use....... if an alarm pop up, you are out of luck.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •