I've recently purchased a stepper motor kit from automation technologies and comes with two 23 nema stepper motor, two KL-4030, a breakout board, 40V and 5V power supply. Is it possible to just run the motor without using the breakout board but just only with the power supply, driver, and motor itself? Also, can any micro-controller software be compatible with the driver?
Thread: Stepper Motor Kit
Results 1 to 2 of 2
Threaded View
-
07-07-2014, 06:32 PM #1
Registered
- Join Date
- Jul 2014
- Posts
- 2
Stepper Motor Kit
Reply With QuoteSimilar Threads
-
UIROBOT:stepper motor,linear stepper motor and stepper driver Yahoo Group
By uirobot in forum Community Club HouseReplies: 0Last Post: 02-26-2013, 08:37 AM -
Power Supply for 4 Stepper Driver 32-65VDC and 4 Stepper Motor 65V 2.3A
By guy2b1 in forum DIY CNC Router Table MachinesReplies: 16Last Post: 03-08-2011, 12:50 PM -
6 leads stepper motor connect to TB6560AHQ stepper driver board
By wf1318 in forum Stepper Motors / DrivesReplies: 2Last Post: 07-25-2010, 08:19 AM -
Integrated stepper motor? with built-in stepper motor driver
By uirobot in forum News AnnouncementsReplies: 0Last Post: 06-07-2010, 09:59 AM -
Beltdrive-stepper motor-stepper motor driver
By Georg in forum Stepper Motors / DrivesReplies: 0Last Post: 10-16-2007, 10:56 PM
Tags for this Thread
automation,
board,
breakout,
breakout board,
controller,
driver,
kit,
kl-4030,
micro,
motor,
nema,
power,
power supply,
purchased,
roller,
run,
software,
stepper,
stepper motor,
supply,
tech
Posting Permissions
