[zimbre]

Hello
Is it possible to automatically choose surfaces and margins when one imports a tool group? It would be otherwise necessary to make the same operation again.

[zimbre]

While we’re at it, how can I get the operation test from the attached picture?

[Fäbe]

Hello
You can also export geometries, there’s a checkbox therefore. But I haven’t tried that myself.

You can delete with deleting of the file “Test” in OPS folder. The path is in your picture above. If there’s an elegant solution, I’d like to know it, too.

Greetings

[zimbre]

In V9 it worked via NC Util/operations/library. It could be deleted there.
There’re many unbelievable things collecting in the course of time.

[zimbre]

You can also export geometries, there’s a checkbox therefore.

I tried to do it. Doesn’t work. It only imports original surfaces.
I saw Cimatron choosing its editing surfaces via levels or colour selection.

For example, the limiting contour of my limiting contour would always be purple etc.

I hope support colleagues of Mastercam know more.