Hello everyone
I have the following question:
Yesterday I have programmed a 3D contour on a work piece, Unfortunately the milling result was dissatisfying.
I first did 3D offset finishing. 0,02mm path distance and Z infeed - result was dissatisfying again because several spaces were not processed at all and also the milling paths were also clearly visible on the part.
I wanted to try finishing it once again with zigzag – however here I was only able to enter the path distance and a Z infeed of 0,5mm- which is way too much for a ball cutter D10 in Vanadis23 HRC65. PEPS kept crashing and several tool paths could not be calculated.
Does anybody know how low the path distance and Z infeed can be for zigzag finishing? I should be able to go down lower than 0,5mm?!

Can anybody help me out?