506,385 active members
2,868 visitors online
Register for free
Login
IndustryArena Forum > CAM Software > Peps > 3D finishing cycle
Results 1 to 2 of 2
  1. #1

    Join Date
    Jan 2012
    Posts
    245
    Hello everyone
    I have the following question:
    Yesterday I have programmed a 3D contour on a work piece, Unfortunately the milling result was dissatisfying.
    I first did 3D offset finishing. 0,02mm path distance and Z infeed - result was dissatisfying again because several spaces were not processed at all and also the milling paths were also clearly visible on the part.
    I wanted to try finishing it once again with zigzag – however here I was only able to enter the path distance and a Z infeed of 0,5mm- which is way too much for a ball cutter D10 in Vanadis23 HRC65. PEPS kept crashing and several tool paths could not be calculated.
    Does anybody know how low the path distance and Z infeed can be for zigzag finishing? I should be able to go down lower than 0,5mm?!

    Can anybody help me out?
    <b><!--coloro:#000000--><span style="color:#000000"><!--/coloro--><!--sizeo:3--><span style="font-size:12pt;line-height:100%"><!--/sizeo--><!--fonto:Arial--><span style="font-family:Arial"><!--/fonto-->Mit freundlichen Grüßen<br /><br />Marcel<!--fontc--></span><!--/fontc--><!--sizec--></span><!--/sizec--><!--colorc--></span><!--/colorc--></b>

  2. #2

    Join Date
    Dec 2007
    Posts
    198
    Hello

    I cannot quite imagine how the part looks like.
    If you are able to post a sketch then I can have a look at it.

    It always depends on the 3D for Offset finishing I would use max. 30 degree!


    For zigzag you definitely get less than 0,5! The easiest way was with the combination finishing- offset and z-constant finishing in one processing (it’s the professional extension which includes trochoidal milling)

    Kind regards

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •