Hello everybody
Since begin 2009 I’ve been working with the version 2008.
Proficam often crashes during 3D roughing in Open GL mode.
In a normal mode usually not.
What can be the reason?
The hotline always say that don’t have time for it…
Hello everybody
Since begin 2009 I’ve been working with the version 2008.
Proficam often crashes during 3D roughing in Open GL mode.
In a normal mode usually not.
What can be the reason?
The hotline always say that don’t have time for it…
Hello
There’s a tool with which Cosmos can access your computer via internet.
I used it several times and it always worked.
A good contact person is Mr. Meerstein (Coscom in Ebersberg)
I have had crashes in Open GL, too.
The reason was either wrong inserted tool or feedstock.
Regards, millingcutter