Hello people!
I’m new here and inexperienced in solidcam.
I have a problem: I have to engrave figures in some details.
How can I do it? I haven’t ever done this!
Hello people!
I’m new here and inexperienced in solidcam.
I have a problem: I have to engrave figures in some details.
How can I do it? I haven’t ever done this!
Hello
Do you mean confirmed numbers or consecutive ones?
If confirmed, then place them into Cad as text and engrave with a profile job.
If they are consecutive, I would use parameter programs by HH. You can find them somewhere in the arena.
Hello,
I would suggest usage of SC font “DPS single…”, because it’s a single line font and you can run midpoint path without font width.
Thorsten
Grüßle<br />nebbe
Exactly, you should use the DPS-single line (it was developed by DPS-software). Open a sketch text, you have to unlock it in Solidworks. Then you can engrave the sketch with 3D engraving.
Hi people!
Where can I find this font? I have searched through the whole PC…
Thanks
High Speed
Hello,
@High Speed:
the font is usually on the SolidCam-CD if you’re a customer of DPS. Certainly DPS isn’t the only distributor.