Good evening
I have the following problem:
When I try to program a tool with an offset of -6,20 mm on a SF20 R5, then Tebis always gives the following message: ’ Offset component part surface invalid’
Even if I give attributes to the surfaces, the same message comes up.
When I build a SF20 R6,3 or take a SF32 R8, then the whole programming works.
Can anybody help me out?
Many thanks in advance
Regards
-domme-
Results 1 to 2 of 2
-
09-20-2011, 07:41 PM #1
- Join Date
- Jul 2011
- Posts
- 26
-
09-21-2011, 05:39 AM #2
- Join Date
- Dec 2004
- Posts
- 594
It is not possible to program bigger than a miller corner radius with a negative offset !!
Unfortunately, I don’t know a trick to bypass this situation, apart from creating Offset surfaces and mill them with an grinding allowance of 0.
wacko.gif<br /><!--sizeo:2--><span style="font-size:10pt;line-height:100%"><!--/sizeo--><!--coloro:#4169E1--><span style="color:#4169E1"><!--/coloro--><b>Alle sagten: Es geht nicht !!<br />Dann kam einer der dies nicht wusste, und tat es</b><!--colorc--></span><!--/colorc--><!--sizec--></span><!--/sizec--><br /><br /><!--coloro:#0000FF--><span style="color:#0000FF"><!--/coloro-->Tebis: CAM Programierung, Datenbank Verwaltung, PP-Programmierung, System Administration<br /><!--colorc--></span><!--/colorc--><!--coloro:#2E8B57--><span style="color:#2E8B57"><!--/coloro-->Heidenhain: iTNC530 Anwender, Cycle-Design, Kinematic Design, und sonstige PLC Spielereien . . . .<!--colorc--></span><!--/colorc--><br /><br />
Reply With Quote
Posting Permissions
