I find Visi great: pockets, drilling and so on... all great. However roughing doesn’t really work so well.
I always do it like this:
For example with a feeder we always use a roughing cycle and say leave 0,25 everywhere. ( floor, sides) It does it at the top, however with each new lift it does it more. Instead of 0,25 0,5 0,6 ...
A constant infeed of 0,5 would do it once when I adjusted it and then twice and that’s not alright.
Before, a feeder was processed once and that was it. Finished! When I do ‘adjusted’ then the grinding allowance fits quite well but it takes considerably longer...
With the 17 it made it, but not since the 18 and 19 anymore. It does 0,25 at the top and with each new lift 0,5-0,6 etc. WHY????
Are my settings wrong?
Does anybody have an idea?
Best regards
Cube3D