Hello
I want to create a 5axial program with visi17. The programming goes alright.
However, the postprocessor only releases a 3 axial program. Could it be that have to reset/ change anything?
I am using a standard postprocessor (fanuc) that came with Visi 17.
Can anybody help me out?
Regards
Steffen
Hello Steffen
You can’t create any simultaneous programs with a 3 axial standard PP.
Who is the Reseller that is responsible for you?
You should talk to him because usually you let an expert adjust your PPs.
3-axis PP / 3+2 - axis-PP / simultaneous-PP
Just out of interest- why are you still using visi17?
<b>Gruß / Regards</b><br /><i><b>CNCFanatiker</b></i><br />AdminCrew<br /><br />Wenn wir immer das tun was wir können, dann bleiben wir immer das was wir sind.<br />If we always this act what we are able to do, then we always remain what we are.