Hello,
I have another bigger aluminium cast piece for 5 axle processing.
IFor this process, I use a clamping device that was created in Topsolid.
When I run the simulation with ‘raw part tracking’ then it jerks and makes 4mm high jumps in the display.
With the second clamping it’s even more distinctive.
The simulation also takes ages…
As a response I increased the display tolerance by 1mm, however I did not notice a noticable improvement.
We work with 32 Bits XP Quadcore computer with Nvidia Quadro Fx 1700 graphic card.
Are there any advantages with 64 bid systems?
Does it help to have two graphic cards in SLI mode?
Are there any TopSolid settings that simplify the simulation?
With best regards
Silvio