Hello
How can I clear a 80mm borehole in a helix with Gibbs?
Regards
Kiki
Thread: Clearing of a borehole
Results 1 to 5 of 5
-
05-31-2008, 06:03 PM #1
Member
- Join Date
- Nov 2004
- Posts
- 160
HAAS VF7 - BJ2008<br />HAAS ST20<br />HAAS ST10 mit Stangenlader<br />HAAS Mikron VCE1000<br />EMCO 365<br /><br />www.KDC-Technik.at
-
05-31-2008, 08:14 PM #2
- Join Date
- May 2007
- Posts
- 156
Do you mean a top down helix or a helix in the XY level?
A top down one works via the plug-in Z-contour ramp with any contour.
-
05-31-2008, 08:41 PM #3
Member
- Join Date
- Nov 2004
- Posts
- 160
Hello
I mean in XY
Regards
KikiHAAS VF7 - BJ2008<br />HAAS ST20<br />HAAS ST10 mit Stangenlader<br />HAAS Mikron VCE1000<br />EMCO 365<br /><br />www.KDC-Technik.at
-
05-31-2008, 10:37 PM #4
- Join Date
- May 2005
- Posts
- 70
Hello
Finally life in the Gibbs Forum
Menu “Plug-ins – geometry – create helix” and/ or “Manual for plug-ins (Gibbs 2007)” page 73<b>Viele Grüße,<br><br>HeinerT</b><br><br>Wenn der Fräser raucht und stinkt, er in den Werkstoff dringt.
-
06-01-2008, 07:50 PM #5
Member
- Join Date
- Nov 2004
- Posts
- 160
Hello
It’s not exactly that what I mean.
I wanted to clear an 80mm hole with a 12mm cutter. And that in a helix. Outside will be made a circle or two.
Regards
KikiHAAS VF7 - BJ2008<br />HAAS ST20<br />HAAS ST10 mit Stangenlader<br />HAAS Mikron VCE1000<br />EMCO 365<br /><br />www.KDC-Technik.at
Reply With Quote
Posting Permissions
