Hello
I was used to have an old Kunzmann with small feed motor in X in our department ( small tool manufacture) . Unfortunately, the machine feel victim to a lift truck mad.gif
Now the boss got an old Deckel FP4 with Contur 3 controller and now I have to handle the machine only according to the manual. coangry.gif I
I am a trained toolmaker but when I was trained, CNC didn’t exist yet (1970). I already made some holes with the drill cycle and also planned some surfaces but it took me ages to write the program.... I think I was for 4 holes at N22 or so and then the machine always went into the wrong direction because I simply forget an – !
Now my question: Is there a simulation program that is similar to the Contur 3 controller so I can practice a little bit?????
Many thanks in advance