584,805 active members*
4,854 visitors online*
Register for free
Login
Results 1 to 2 of 2
  1. #1
    Hi

    I'm have the following problem on my Deckel FP4AT with Contour3 controller:

    I need to produce a cube-like component part with an annular groove on each side. Now I would like to describe this groove in a macro and call in every program for every side at a specific location.
    Now to my problem:
    I go to my macro list when I press %0* Then I create a macro program, e.g. % 0 * 1 and then try to select it.

    Nothing happens ....

    a normal program can selected. I also have the problem with a local subprogram.

    Who can help me???


    Greetings Adam

  2. #2
    I have not worked for ages on this controller.

    As far as I can recall it, the editing the macros is similar to the N *- sentences: Usually you need to use a key combination to switch in the program editor. Try it with FKT%.

    greetings
    cgTNC

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •