[Flyingmatt]

Hello everybody

I am looking for a possibility to jump from a main program ( work piece 1. WPD) into a ‘program part’ of another main program (work piece 2.WPD) on a Index G200 (Siemens 840D controller)

The manual says that I should write MPF+ program name. ( manual programming).
However it doesn’t work. It can’t find a program.
According to the book:
Search strategy of the controller :
1.Is there a *_MPF?
2.Is there a *_SPF?
The command EXTCALL ‚work piece 2‘ doesn’t work either.
Looking forward to your answers.

[INDEX-Service]

Hello
I guess it’s not possible to jump into another WPD.
Can you not integrate the necessary program parts into the existing work piece? ( via UP)

Regards
INDEX service

[Flyingmatt]

Hello
I guess it’s not possible to jump into another WPD.
Can you not integrate the necessary program parts into the existing work piece? ( via UP)

Regards
INDEX service

[Flyingmatt]

Ok according to the manual it works.
So, I jump from a WPD file into the sub program of another ‘loaded’ WPD file.

Manual: work preparation from page 163

[InTex]

Yes it works, It was already possible on a INDEX GFG250 with Sinumerik 3T controller