Hello everybody
I am looking for a possibility to jump from a main program ( work piece 1. WPD) into a ‘program part’ of another main program (work piece 2.WPD) on a Index G200 (Siemens 840D controller)
The manual says that I should write MPF+ program name. ( manual programming).
However it doesn’t work. It can’t find a program.
According to the book:
Search strategy of the controller :
1.Is there a *_MPF?
2.Is there a *_SPF?
The command EXTCALL ‚work piece 2‘ doesn’t work either.
Looking forward to your answers.