Good morning,
I have a problem with our Okuma machines, a P100 controller, a U10L but both have the same problem:
If you take out a part after thread turning and you put it in again afterwards, then it’s impossible to get the machine back into the same thread. With our Siemens machine its really easy, simply drive into the thread with the threaded steel, press sync. Button- and its done!
Okuma doesn’t have such a function, doesn’t it? And if you increase or decrease the speed when thread turning, then you can see exactly how the steel runs out of the thread. That’s also not the same with the Siemens.
Would be grateful for any help!